VESTIL PRTD-10-42-24 Steel Pallet Racking Frame, 10 ft x 42 Inch, 24000 lb Capacity, Green

Compatible Accessories:

Vestil Pallet Rack Beams: They are used to join the uprights of the rack to form a bay or section of pallet racking. In order to properly position the uprights, this pallet racking frame might require the installation of two beams.

Standards and Approvals:

• OSHA

Frequently Asked Questions:

Q. How many uprights are needed for two 'runs' on pallet racking?

A. You will need 3 Vestil PRTD frames for two continuous 'runs' on the pallet racking.

Q. How to install Vestil PRTD-10-42-24 24 pallet rack frame?

A.

• Place the pallet rack on a flat & even surface. When deciding where to install, keep in mind the need for aisle space to accommodate lifting equipment.
• Place an upright frame in the desired location and mark the floor with bolt holes in the footpads.
• Anchor bolts should be 1/2 inch in diameter to match the bolt holes in the footpads of the upright frame pieces.
• Drill anchor bolt holes and install anchoring devices.
• Slide a lock washer followed by a flat washer onto each bolt, before bolting the upright frame to the ground.
• The bolts should then be inserted through the bolt holes in the footpads and into the anchoring device.
• Insert the beam locking tabs (at the same height on both ends, so that the beam is level) into the teardrop openings in the uprights to install the beams.