TRICO 30068 Constant Level Oiler, Type EB, 8 oz. Capacity, 2-5/8 Inch Size, Plastic Reservoir

Compatible Accessories:

• Trico 36470 Opto Laser Level: These tools are used as an inspection device to accurately set / level this Opto-Matic oiler if improperly installed or used.
• Replacement Parts: Raptor Supplies offers parts & accessories like reservoir assemblies, castings, set screws & pipe plugs to replace the old, worn-out or damaged parts in Trico 30068 Opto-Matic oiler.
• Trico Oiler Wire Guards: These wire guards are fitted over the reservoir of this oiler to prevent potential accidents.

Standards and Approvals:

• ISO 9001:2015
• ISO / IEC 17025:2017
• ASTM

Frequently Asked Questions:

Q. What is the reservoir capacity of this Trico 30068 Opto-Matic oiler?

A. Trico 30068 Opto-Matic oiler's reservoir has a capacity of 8 ounces.

Q. How is this Trico 30068 Opto-Matic oiler installed?

A.

• Before installing, determine the shaft rotation direction.
• Install the oiler on the side of the equipment facing the direction of shaft rotation to prevent misfeeding of the oiler.
• Determine equipment's proper oil level. Loosen the set screw and remove the reservoir.
• Connect the lower casting of this unit to the bearing chamber using side or bottom connections. Level it properly & mark the desired oil level.
• Measure the distance between the unit and the top edge of the spout angle. Mark this distance above the line made in the above step as X.
• Fill the equipment bearing chamber through the unit's lower casting until the oil level reaches the desired level mark.
• Fill 2/3 of the reservoir using the recommended oil using a funnel. Place a thumb over the reservoir spout & invert it over the lower casting. Insert the reservoir assembly till its bottom edge reaches the X mark.
• Tighten the set screws on the reservoir assembly and start the process to check for the proper functioning of the oiler.

Q. What is the maximum temperature to operate this Trico 30068 Opto-Matic oiler?

A. This Opto-Matic oiler can operate at a continuous temperature of 165 degrees F.