MILWAUKEE VALVE 2882-M 2 Gate Valve, 2 Inch Nominal Valve Size, Cast Iron, Non-Rising, Class 125 Flange, Wheel

Milwaukee 2882-M 2-inch gate valve is used to control, stop or allow the flow of fluids in oil & gas, chemical & industrial pipelines. This Milwaukee gate valve has pressure ratings of 125 psi SWP to 200 psi WOG.

Features:

• Milwaukee 2882-M 2-inch gate valve has IBBM design (cast iron body & bronze mounting seat) for strength & durability.
• It has flanged end connections with bolted bonnet & gland packing for connecting to piping.
• This Milwaukee gate valve has a non-rising stem and solid wedge disc for controlling the flow easily.

Standards and Approvals:

• MSS SP-70, Type 1

Frequently Asked Questions:

Q. How is this Milwaukee 2882-M 2-inch gate valve installed?

A.

• Clean the piping system thoroughly before valve installation.
• Remove valve end caps & any packaging from the valve and inspect the valve ports & seating surfaces.
• Provide support to the valve to prevent unwanted stresses. The valve should have an adequate straight pipe from the equipment to prevent vibrations.
• Use full-face gaskets & centre them to prevent internal valve leakage.
• Bolt the flange inline using full-face gaskets.
• Verify the tightness & proper installation of the valve by operating it from fully open to close positions.

Q. What are the steps for the maintenance of this Milwaukee gate valve?

A.

• Adjust the stem packing & the cycling of the valve from open to closed position periodically.
• In case of a packing leak, increase the pressure on the stem packing by adjusting the packing gland nut in the clockwise direction until the leakage stops.
• The packing should be changed whenever a new stem is installed.