EATON ED2125 Molded Case Circuit Breaker, F-Frame, 2-Pole, 125A, 240 Vac, 125 Vdc, 50/60 Hz

Eaton ED2125 circuit breaker is an Eaton C Series circuit breaker that prevents electrical damage to connected devices due to excess current or short circuits. It has a completely moulded case with an F-frame for housing current-carrying parts, trip devices & mechanisms inside it, enhancing durability. This circuit breaker can protect devices like receptacles, branch circuits, external motors and HVACs.

Features:

• Eaton ED2125 circuit breaker has bolt-on mounting style and line & load terminals for easy installation on panels and installation of circuit wires, respectively.
• This 2-pole complete breaker is equipped with fixed thermal & magnetic contacts for long-time and instantaneous tripping performance.
• The unit's sliding handle has three positions (ON, OFF and trip) for easy identification of the breaker's status.

Compatible Accessories:

• Load Centres, Panels & Switchboards: This Eaton ED2125 breaker can be installed easily onto panelboards, switchboards & load centres.

Standards and Approvals:

• UL

Frequently Asked Questions:

Q. What are the different performance ratings of this Eaton ED2125 circuit breaker?

A. Eaton ED2125 breaker has a current rating of 125A, a voltage rating of 240VAC / 125VDC and an interrupt rating of 65kA at 240VAC.

Q. How to install this circuit breaker?

A.

• Mount this unit on the panel or mounting surface, ensuring that the accessory wirings are reachable and the unit can be mounted. Install & tighten the breaker mounting using screws, washers & nuts.
• Install an optional terminal end cover. Connect the line & load terminals with the accessory leads and install a terminal shield & interphase barrier if needed.
• Finally, check all the mounting & terminal connecting hardware.

Q. What are points to inspect before operating this Eaton ED2125 circuit breaker?

A.

• Remove the dust, dirt, grease, moisture or foreign contaminants from the unit.
• Check that the unit's switch is free to move by switching the unit ON & OFF several times.
• Press the optional push-to-trip button at the bottom side of the unit to mechanically trip & test for proper functioning.
• Inspect the unit of any cracks, chipping or discolouration. Tighten the terminals & connectors. Check the mounting hardware.
• Remove any safety hazards near the installed area.