TRICO 30078 Constant Level Oiler, Type EH, 8 oz. Capacity, 2-5/8 Inch Size, Plastic Reservoir

Compatible Accessories:

• Trico Oiler Wire Guards: These wire guards protect the reservoir of this oiler from potential accidents.
• Trico 36470 Opto Laser Level: These tools help in accurately setting / levelling this Opto-Matic oiler if improperly installed or used.
• Trico Oiler Replacement Parts: Raptor Supplies also offers replacement parts & accessories like reservoirs, upper castings, lower castings, set screws & pipe plugs for replacing the old, worn-out or faulty parts in this Opto-Matic oiler.

Standards and Approvals:

• ISO 9001:2015
• ISO / IEC 17025:2017
• ASTM

Frequently Asked Questions:

Q. What are the steps to install this Opto-Matic constant level oiler?

A.

• Before installing, determine the shaft rotation direction.
• Install the oiler on the side of the equipment facing the direction of shaft rotation to prevent misfeeding of the oiler.
• Determine equipment's proper oil level. Loosen the set screw and remove the reservoir.
• Connect the lower casting of this unit to the bearing chamber using side or bottom connections. Level it properly & mark the desired oil level.
• Measure the distance between the unit and the top edge of the spout angle. Mark this distance above the line made in the above step as X.
• Fill the equipment bearing chamber through the unit's lower casting until the oil level reaches the desired level mark.
• Fill 2/3 of the reservoir using the recommended oil using a funnel. Invert it over the lower casting. Insert the reservoir assembly till its bottom edge reaches the X mark.
• Tighten the set screws on the reservoir assembly and start the process to check for the proper functioning of the oiler.

Q. How is this Trico 30078 Opto-Matic oiler installed on equipment?

A. Trico 30078 Opto-Matic oiler has 1/4 inch NPT connections at the side of the unit for easy installation on the equipment.

Q. What is the maximum temperature to operate this Trico 30078 Opto-Matic oiler?

A. This Opto-Matic oiler can operate at a continuous temperature of 165 degrees F.