TRICO 30058 Constant Level Oiler, Type E, 8 oz. Capacity, 2-5/8 Inch Size, Plastic Reservoir

Compatible Accessories:

• Trico Reservoir Assemblies with Set Screws: They are used to replace old / worn out / damaged oil reservoirs.
• Trico Opto Laser Levels: They act as inspection devices for indicating the accurate setting of the level of oil in Opto-Matic oilers.

Standards and Approvals:

• ISO 9001:2015
• ISO / IEC 17025:2017
• ASTM

Frequently Asked Questions:

Q. Is Trico Opto-Matic oiler corrosion-resistant?

A. The casting and internal parts are zinc plated and the reservoir is made of butyrate plastic to withstand harsh weather and resist corrosion.

Q. At what temperatures does Trico 30058 Opto-Matic oiler work?

A. This Opto-Matic oiler can work at temperatures up to 165 degrees Fahrenheit.

Q. How is Opto-Matic constant oiler installed?

A.

• Before installing, shaft rotation direction must be determined.
• Install the oiler on the side of the equipment facing the direction of shaft rotation to prevent misfeeding of the oiler.
• Determine the proper oil level either indicated by an arrow or manually marked using a marking device.
• Loosen set screw and remove reservoir assembly.
• Check that all connecting hardware is free from contamination.
• Connect lower casting to the bearing chamber and verify that the casting is parallel with the desired oil level.
• Measure the distance between the oiler & casting edge and set the oiler level adjuster i.e. Opto laser level tool.
• Thread the upper adjuster arm to the needed level and once the correct level is obtained, lock the lower level adjuster arm against the upper arm.
• Fill the equipment bearing chamber through the lower casting and use a funnel to fill the reservoir assembly.
• Tighten the set screw and start the equipment.