ENERPAC HC7206 High Pressure Hydraulic Hose, 1/4 Inch Inside Diameter

• Enerpac HC7206 hydraulic hose for transferring water & petroleum based fluids in hydraulic systems for mining & construction applications
• Thermoplastic construction with polyurethane cover & carbon steel reinforcement for high strength, flexibility and protection against cuts in harsh industrial environments
• Vinyl strain relief guard on both ends of the hose to protect against stresses and axial tensions
• Shows low volumetric expansion under pressure for enhanced efficiency
• Maximum operating pressure of 10000 psi
• 4:1 safety factor for hazard-proof operation

Frequently Asked Questions:

Q. How to replace any hose with this Enerpac HC7206 hose?

A.

• Firstly, depressurise the hydraulic system and turn off the power supply.
• Then, identify the faulty hose by inspecting it for wear, leaks, or damage.
• Next, position a drain pan beneath the hose connection to avoid spilling fluids.
• Then, loosen and remove the fittings that secure the hose.
• Carefully remove the old hose from its connections, noting its routing and length.
• Later, cut the replacement hose to the required length, if necessary, using a tubing cutter.
• Finally, install Enerpac hydraulic hose by connecting it to the appropriate hydraulic connections.

Q. How to be safe while replacing a hydraulic hose?

A. Hydraulic fluid is toxic and can cause skin problems. Therefore, always wear gloves and protective glasses while replacing a hose. Also, wear coats with long sleeves or pants.