DAYTON 5DVN6 Upblast Ventilator Wheel 8-1/4 Inch 115v

Dayton 5DVN6 upblast ventilator allows continuous operation to vent out fumes, odours, foul air and grease-laden vapours.

Features:

• Dayton 5DVN6 upblast ventilator is equipped with a variable speed motor and has electronically commutated motor (ECM) technology to operate on an AC power supply, thus maintaining proper airflow through the system.
• This unit has a potentiometer dial mounted on the motor to manage speed.
• It features a spun aluminium curb with a galvanised metal motor base & supports for corrosion-resistant performance.
• The motor compartment is cooled by fresh outside air.

Standards and Approvals:

• NEMA
• AMCA
• CSA
• UL / cUL 705

Frequently Asked Questions:

Q. What is the maximum inlet temperature of this ventilator?

A. It can handle inlet temperatures up to 130 degrees Fahrenheit.

Q. What tools are required for assembling this ventilator?

A.

• Dayton roof curb and mounting fasteners
• Sealant or chaulk
• Tachometer

Q. How to install this upblast ventilator?

A.

• Fabricate an appropriately sized hole in the roof surface.
• Caulk and flash curb for a water-tight seal.
• Mount optional backdraft damper and secure the damper flange to curb damper tray.
• Remove the motor compartment cover by unscrewing fasteners.
• Position the cover on a flat surface in an area protected from strong winds.
• Lift and place the unit on top of the roof curb and secure the ventilator to the roof curb using a minimum of eight fasteners.
• Rotate the wheel by hand so that it does not rub and thus, rotates freely.
• Check all the fasteners for tightness.
• The motor's voltage and amperage rating must be checked for compatibility to the supply voltage prior to final electrical connection.
• Install and wire safety disconnect switch under the ventilator cover and wire the motor as per the connection wiring diagram.
• Screw back the motor cover.