VULCAN HART Sight Glass Assembly
Vulcan Hart sight glasses are designed for viewing the level of the liquid / gas that travels through critical points of the equipment, monitoring pressure changes within a tank or boiler.
Filter
A
BFeatures
- These units indicate the water level in Vulcan Hart's jacketed kettles and food steamers for optimised performance. The level below the mid-of-sight glass may cause damage to appliances.
Frequently Asked Questions
How to install a new water level gauge assembly?
- Close the valve at the top & the bottom of the gauge assembly.
- Unscrew the packing nuts at the top and bottom of the glass tube.
- Slide the glass tube up until the bottom of the tube is clear of the fitting.
- When reinstalling the tube, use new sealing washers. Do not overtighten the packing nuts, as this could break the gauge glass.
- Ensure that both top and bottom valves are fully open.
How to measure the correct water level in a gauge assembly?
The correct water level is a point one-half of the height of the sight glass.
When do we clean the food steamer?
If the water in the sight glass becomes extremely murky, the generator should be blown down or cleaned, else it would cause bad water conditions.
We are here to help!
Looking for a part not listed here?
Explore More
- INFICON
- KEYSHAFT
- SHARKBITE
- POWERTWIST
- QUOIZEL
- Tire Valve Stems and Cores
- Strain Relief Grips
- Reference Guides
- Fiber Optic Cable
- Voltage Sensor Relays
- VERMONT AMERICAN High Carbon Steel Metric Taps
- KRYTOX FPG 028 Series Type IV Aerospace Grease
- TEMPCO TKZ Series Analog Temperature Controllers
- TEMPCO Bayonet Adaptors
- GLOBE SCIENTIFIC Plug Stoppers, For 16 mm Tubes
- BURNDY Hydraulic Hose
- GRAINGER 4mm Steel General Dowel Pins
- APPROVED VENDOR M6 x 1 Partially Threaded Plain Stainless Steel Round Thumb Screws
- TUNGALOY WNMG-TA Turning Indexable Inserts
- MIDWEST Binding Barrels And Screws, Aluminum