Pressure And Vacuum Switches

Condor pressure switches are designed for use with air compressors and are used to pressure, monitor and control oils, liquids & gaseous media in tanks & pipeline systems. These pressure switches come equipped with an actuation type diaphragm which allows precise opening & closing of the valves and die-cast aluminium flanges provide increased strength in high-pressure applications. They also feature a clear enclosure for protection against harsh environments and a visible pressure scale for accurate pressure measurement. These GL and UL approved pressure control switches can withstand pressures up to 250 bar and are ideal for air pressure, shipping, vacuum & heating systems. Choose from a wide range of pressure control switches, available in standard and standard/reverse action variants on Raptor Supplies.

Honeywell pressure switches are used to provide electrical feedback in response to a chamber either rising or falling to a pre determined pressure level. These units feature a glass-reinforced polyester enclosure with a screw terminal connection capable of field adjustments and a Kapton diaphragm compatible for use with a wide variety of fluids. They are further designed to work in conjunction with different terminations (Metri-Pack connector) which forms a tight seal when connected. Choose from a broad range of these pressure switches available in 750 PSI and 1250 psi burst pressure variants on Raptor Supplies.

Condor pressure switches are designed for application in air compressors. These pressure switches are made in compliance with CSA and UL standards. They feature an auto-off disconnect lever to cut off the compressor and an unloader valve to avoid compressors from starting under load. These switches have operating temperatures ranging between -22 degrees Fahrenheit and 257 degrees Fahrenheit, and can withstand 35 bar maximum cut-out pressure. They have switching capacity of up to 7.5 kW and can work in single- and three-phase power supply.

Dayton water pump pressure switches are used for direct control of electrically driven pumps. These switches feature diaphragm actuation for fail-safe operation and DPST contacts for controlling two circuits at the same time (either both circuits are OFF or both are ON). They are capable of handling burst pressures and temperatures up to 290 psi and 250 degrees F, respectively.